Guide to Drying Cannabis

Drying cannabis is easy, it just takes space and time. The drying process should take 3–14 days, depending on relative humidity and temperature.

Right after you harvest, the plant matter will still be full of chlorophyll. The goal is to get as much chlorophyll as possible to be changed into glucose. Before the drying, it will taste unsavory and bitter, and it will definitely not be ready for use. The process only takes a few days of drying, but it is absolutely vital that you do it right.

Make sure to put as much effort into drying and curing as you did to growing your cannabis plant. This will have a major role in what your buds taste and smell like. Cutting short on this will cost you all the effort thus far.

Cutting

drying-in-closet-after-harvest.png

There are different ways to cut your plants depending on your preference.

  • Cutting the plant down at the base and hang the whole plant upside down to dry.
  • Cutting off branches and hang them to dry.
  • Cutting off individual buds, laying them out, and drying them on a mesh screen or rack.

The most popular way is to cut 12-16” branches from the plants, remove unwanted leaves, and then hang the branches from string or wire

Trimming

41219.png

Before starting the drying process, most growers will trim away extra leaves.

The biggest factor when deciding whether to trim your buds or not is the relevant humidity of your drying space.

Dry (Under 30% RH) – You might consider leaving most (or all) of the leaves untrimmed to help slow down the drying process. The more plant matter left behind, the slower the buds will dry 

Optimal Drying Environment – If humidity is not a factor, feel free to trim as much or as little as you would like

Humid (Over 60% Humidity) – You might want to consider actually separating buds from branches after trimming and put them on a drying rack or mesh to help speed up the drying process and prevent mold

The main objective while drying is to make sure you are not drying too slowly or too quickly.

CompleteAd

Tip: As you are trimming you may want to save your trim (resin-covered leaves or tiny buds you’ve trimmed off). These extra leaves are not good to smoke by themselves, but after being dried, the trim can be processed to make marijuana butter or other cannabis extracts.

How To Dry

Broken-Coast-Cannabis-14.png

Never let buds touch each other during the drying process

It’s very important to check your buds often throughout the drying process. If they begin to get too crispy, they are getting too dry and you need to gently increase humidity. If parts of the buds aren’t drying, you may need to adjust air circulation and decrease humidity but be careful if adding a fan, not to point it directly onto the buds.

Hanging the buds upside down and providing good spacing and airflow allows the moisture to dissipate at a slow but steady pace. This is considered the “standard” way of drying and can be done on clothes hangers, string, or almost anything you can think of. The stem will drain its moisture into the center of the bud as the outside draws the moisture out. It also gives a good indication of how far along you are in the drying process. Drying is complete when small stems snap instead of bend, and buds feel dry to the touch, but not crispy.

Taking the buds off the stem and placing them on drying racks will allow you to fit more bud into a smaller drying area. A drying rack will dry your buds faster than most of the other methods because the stems are removed from the buds (and the stems contain a bit of water). Using a drying rack is the preferred drying method if you live in a humid area where mold is a problem, if you’re drying a lot of buds in a relatively small space, or if you have huge colas or buds that you’re worried might mold. Just make sure there is plenty of airflow. Additionally, because there is no stem to hold water, the buds dry very quickly. When the bud is quickly dried it makes the cannabis much harsher tasting. Also, buds that dry on the screen often end up with a flat spot on one side that leaves them with a bit of a smashed look.

mj.png

Other ways of drying can include drying buds in paper bags or even laying them out on cardboard. Just make sure that if you’re laying your buds on something flat like cardboard, you realize that it can create wet spots, and will leave an imprint on the sides of your buds where they touched the flat surface.

Regardless of which method you prefer, you will need to keep the harvested cannabis in a dark room with temperatures kept within the 60-70°F range and humidity between 45-55%

3-14 Days Later

How-to-Cure-Weed.jpg

You will know that your buds are finished drying when buds feel dry to the touch, and smaller stems snap instead of bend and buds will “snap” off without leaving a stringy trail.

  • If your buds are dry sooner than 3-4 days, it may mean you’ve dried your buds a little too quickly. Drying too fast will cause the next step (the curing process) to take a little longer than normal.
  • If you accidentally over dry your buds by drying for too long, the curing process slows down dramatically, or may even come mostly to a halt. However just like buds dried too quickly, over dried buds will still cure, but it takes longer. Remember, you do not want your buds to crumble or seem dusty in your hands.
  • If you pull down your buds before they are done drying, you’ll find they tend to be too wet once you put them in jars. In this case, it’s better to take buds down too early and have to dry them some more than over dry them.
  • If your drying method included removing the stem, it’s important to jar buds as soon as the outsides feel dry to the touch, before the buds dry all the way through, since there won’t be any stems to “hold onto” some extra water.
  • If you notice that any buds feel damp or moist, do not store them in the jars yet! Allow those buds to continue drying slowly until they start to feel dry on the outside before putting them in jars. If they’re already in jars and feel moist, make sure to leave the tops of the jars off until the buds feel dry again. Buds should always feel completely dry on the outside, and shouldn’t stick together. If you ever smell “ammonia” it means they’re too wet and bad bacteria is starting to grow.

Ready To Start Curing

marijuana-jars.jpg

When you’re ready to start curing, you’ll need enough containers to hold all of your buds without being more than 75% full. Buds should not be more than 3 inches in length and should have their stems and leaves removed before beginning the curing process.

 

OGad

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s